The open mill is an essential equipment in rubber product factories. During the use of the open mill, there may be some malfunctions caused by misoperation. If there are major problems, you can directly contact the manufacturer for repair. For minor faults, we can repair them ourselves. Here, Guangdong Lina Wang reminds everyone to pay attention to the following three aspects when repairing their own open mill

1. Disassemble the transmission gear

Pay attention to marking the corresponding meshing teeth of a set of gears, and install them according to the original meshing teeth position during assembly to avoid increasing the noise of gear meshing transmission in the open mill.

2. When grinding the working surface of the open mill roller, try not to reduce the diameter of the working surface too much until it can meet the working requirements, in order to avoid meshing interference caused by gear transmission at the roller end.

3. If the meshing teeth of the spur gear are severely worn, the pair of open mill gears can be flipped 180 ° and assembled to reduce the meshing transmission noise of the other involute teeth of the pair of gears.

Guangdong Lina Wang reminds everyone to pay attention to disconnecting the power supply when repairing the open mill. Safety comes first. To avoid causing safety accidents.